Benchtop Resin Dispenser for Sensor Encapsulation

Sensors live in harsh places. Water, vibration, oil and heat all go after the electronics inside. Encapsulating them with a metered two part resin gives a seal that is the same on every unit, so field failures drop and warranty claims go with them. Gear pump, piston and progressive cavity technologies are all on offer, so the machine can be matched to the material rather than the other way round. Epoxies, polyurethanes, silicones, acrylics and thermal pastes are all handled across a wide range of mix ratios. Benchtop systems meter each component by volume, mix through a static mixer and dispense a controlled shot or bead. Ratio holds steady, shot sizes repeat and the operator stops guessing. Whether the job calls for a thin, free flowing resin or a heavy, filled paste that will not move on its own, the equipment is specified around the material. Single part and two part products are both covered, at standard and awkward mix ratios. Buyers usually come to Rockingham Systems with one of three problems: too much material wasted, too many rejects, or a manual process that cannot keep up.

Metered dispensing tackles all three. Accurate metering cuts rework and scrap, keeps cured properties consistent and takes the guesswork out of every shift. Every system is backed by installation, operator training, spares and technical support from the UK team. Speak to Rockingham Systems on +44 (0) 1536 628 734.