Replacement Dispense Valves for Existing Lines

Worn valves cause drips, inconsistent beads and downtime. Replacement valves matched to your existing system restore performance without a full rebuild. The valve is where material meets the part. Clean cut off, consistent flow and compatibility with the material decide the quality of the finished bead. Valves are matched to material, viscosity and feed system, covering bead, dot and fill applications with single and two part materials. Whether the job calls for a thin, free flowing resin or a heavy, filled paste that will not move on its own, the equipment is specified around the material. Single part and two part products are both covered, at standard and awkward mix ratios. Buyers usually come to Rockingham Systems with one of three problems: too much material wasted, too many rejects, or a manual process that cannot keep up. Metered dispensing tackles all three. Accurate metering cuts rework and scrap, keeps cured properties consistent and takes the guesswork out of every shift.

Talk through your material, ratio and output with the Rockingham Systems UK sales team on +44 (0) 1536 628 734. Service and consumables contracts are available.